Garage Door Garage Door Cable Repair Yonkers, NY
For garage door cable repair in Yonkers, experience with Westchester County pays off: Westchester County, New York, takes in Yonkers and the communities around it. We know what the area's doors need.
Because Yonkers has four distinct seasons of muggy summers and freezing, snowy winters, with wide annual temperature extremes, the doors here age differently than inland or coastal homes elsewhere. The usual culprits are ice that binds the bottom panel to the threshold, freeze-thaw cycles that crack seals and loosen hardware, and wide seasonal swings that work bolts loose over time — exactly what our techs come prepared for.
The calls we get most in Yonkers are loosened hardware from wide seasonal swings, warped or sagging panels after years of freeze-thaw, freeze-thaw-cracked bottom seals, and corroded low brackets from winter slush. Each is something our trucks are stocked to fix on the first visit — no waiting on parts.
Lift cables transfer the spring's stored energy to the door panels — they're under high tension every cycle and degrade slowly through fraying, corrosion, and mis-spooling on the drum. A cable repair visit replaces both cables (always replace as a pair so the door stays balanced), re-spools the drums to the correct number of wraps, recalibrates spring tension to match, and inspects related components like the bottom bracket where one end of each cable terminates.
Cables are galvanized aircraft-grade steel — typically 1/8-inch diameter for residential doors and 3/16-inch for heavier or commercial doors. We carry both diameters along with the bottom-bracket fittings, drum caps, and shaft set-screws that occasionally need replacement alongside the cables.
Cable failure usually leaves the door off-track or hanging crooked. Continuing to operate the opener after one cable has snapped causes the other side to take the full load and is the fastest way to bend tracks or damage panels. Stop the opener and call for repair when you see a frayed or snapped cable — fast service is standard.
Signs you need garage door cable repair
Frayed cable visible at the drum
Strands of steel poking out of the cable indicate active wear. Cables don't self-heal — frays accelerate to snap.
Door hangs crooked when closed
If one corner is higher than the other when the door is fully down, one cable has stretched, slipped on the drum, or partially failed.
Snapped cable, door stuck
A fully snapped cable leaves the door off-track or jammed. Don't try to force it — call for repair.
Rust streaks on cables
Coastal homes see cable corrosion progress until the strands weaken. Visible rust means the cable is no longer at full strength.
Loud bang followed by crooked door
Cable snap sounds similar to spring snap but is usually quieter. If the door is crooked after the noise, suspect cable failure.
Common causes & what we fix
Mis-spooled drum
When a cable jumps off its drum groove, it crosses over itself and wears at the crossover point. Re-spooling fixes the spool but the wear point becomes the weak link.
Drum cap or set-screw failure
If the drum slips on the shaft, one cable unwinds while the other tries to hold. This sudden imbalance can snap the loaded cable.
Bottom bracket failure
The bracket where the cable attaches at the door bottom occasionally cracks or pulls free, letting the cable whip free under tension.
Coastal corrosion
Salt-air pitting on uncoated cables can drop tensile strength 30–40% over 10+ years. Galvanized aircraft cables resist this far better.
Spring imbalance
An over- or under-tensioned spring puts uneven load on the cables and accelerates wear on the loaded side.
Our process
- Call or schedule online. Booking garage door cable repair is two clicks or one call: select a 2-hour window and get a named, photo-tagged tech confirmation within five minutes.
- On-site diagnosis. On-site, we pinpoint the garage door cable repair fault and show it to you. Diagnosis is free for most repairs and $39 for minor service calls — waived the moment you proceed.
- Flat-rate quote. We quote garage door cable repair for Yonkers at a flat rate, in writing, before any work — no hourly billing, no commissioned upselling. The number doesn't move once you approve it.
- Same-visit fix. Nine times in ten — 96%, really — the garage door cable repair is done in one visit. You watch the final test cycle, and we haul off every old part and bit of debris.
How much does garage door cable repair cost in Yonkers, NY?
Expect garage door cable repair in Yonkers to start at $149, with the final flat rate confirmed in writing before work starts. There's no diagnostic surprise and no hourly billing — just one number you approve before we begin.
Garage Door Cable Repair the United States starts at from $149, and we quote garage door cable repair at a flat rate in writing before lifting a tool — no hidden add-ons, no hourly creep. A 10% labor discount applies for seniors (65+) and military, and Synchrony offers 0% APR for 12 months on projects over $1,500, approved quickly with no prepayment penalty.
Why homeowners in Yonkers, NY choose us for garage door cable repair
Yonkers homeowners book our garage door cable repair because we're local to New York's continental-climate region, fast to dispatch, and honest about repair-versus-replace. 96% first-call fix rate, CSLB #1098234.
Garage door cable repair is guaranteed ten years on our workmanship — a promise that sits apart from the manufacturer's parts coverage. If the garage door cable repair we performed fails because of our install, the fix is free for the full decade. 30,000-cycle springs are lifetime-warrantied for the original homeowner, and parts and accessories run 1–5 years.
Our garage door cable repair quotes in Yonkers are built on honest scope: no padded line items, salaried technicians with no commission to chase, and a transparent diagnostic so you see the real condition of every part. We'll tell you straight whether to repair or replace, and the flat-rate garage door cable repair quote is written and good for 30 days.
Areas we serve for garage door cable repair
We provide garage door cable repair throughout Yonkers, NY and the surrounding Westchester County area. Serving Yonkers and surrounding neighborhoods.
Some geography behind our garage door cable repair: Westchester County, New York, takes in Yonkers and the communities around it. Yonkers is inside that, and we cover the whole of it.
Neighbors of Yonkers — including Bronxville, Tuckahoe, Mount Vernon, and Hastings-on-Hudson — get the same garage door cable repair. Our trucks already pass through, so adding your stop rarely adds wait.
Garage Door Cable Repair near you in Yonkers, NY
Searching "garage door cable repair near me" from Yonkers? You've found a genuinely local option. Our crews work Yonkers and the surrounding area and neighboring Bronxville, Tuckahoe, Mount Vernon, and Hastings-on-Hudson every day, so the tech who shows up actually knows your area — not a national call center routing the job out of state.
Our garage door cable repair coverage spans ZIP codes 10708, 10703, 10701, 10707, 10705, 10704 and out past them. How fast we reach you for garage door cable repair depends on Yonkers traffic and the hour, so we give a real ETA the moment you call. The line rings an on-call tech directly — never a voicemail box.
Frequently asked about garage door cable repair
Top questions homeowners searching for Garage Door Cable Repair near me ask us: